POE-PAN12-GB

This single POE-PAN12-GB panel can feed 12 devices with a PoE extractor using passive PoE injectors. It is a cost-effective solution for remote PoE powering of wireless devices, IP phones, IP cameras and the like. Without this injector, you would have to buy new expensive PoE switches or multiple individual injectors. If a powered device does not have a POE extractor, it can be combined with a passive POE splitter. This version boasts support for up to 1Gbp/sec through Gigabit Ethernet and mainly through the 19" rack.

Key features of the POE-PAN12-GB

• Bulk, economical PoE power supply
• It can handle 12 PoE devices from a 19" rack
• Supports Gigabit Ethernet and passive PoE
• Current protection up to 650mA (+/- 15%) at each port
• Three-stage LED signalling of current values on three groups of ports
• Compatible with power 1/2- and 3/6+ pins (CISCO ...) and 4/5+ and 7/8- (MIKROTIK, UBIQUITI ...)
• Source not included (buy according to the subscription)

Gigabit PoE-PAN12-GB PoE Injector with easy Installation

This device is not complicated to set up. The main part of the installation consists of connecting the cables. Simply connect the ethernet ports from the existing network from one side of the POE-PAN12-GB and, on the other hand, plug cables into the PoE devices that use the data line at the same time for power. Two 2,1mm jacks are used to power the POE-PAN12-GB.

Parameters and Specifications:

Interface:
12 × RJ-45 shielded input (data)
12 × RJ-45 shielded output (data + power supply)

Input:
2 x 24 - 57V DC 2.1 mm connector (120W)

Ethernet:
TIA / EIA 568 Cat. 5
Dimensions:
482.6 × 44.3 × 52mm

Weight:
1.2kg