Solight wireless, white, learning code and 2× receiver (for socket and battery)

The white design of the Solight wireless doorbell with clean lines looks unobtrusive and elegant, while at the same time blending in with most interiors and not disturbing the overall appearance of the room. One wireless doorbell just needs to be plugged into a regular socket, no drilling or pulling cables required. The second can be transferred at will. A range of up to 200 metres in open areas ensures trouble-free operation. The doorbell offers a choice of 36 melodies and 4 volume levels. The "learning code" encoding allows you to add multiple bells or buttons to a group and eliminates interference from other bells in the vicinity.

Pairing function "Learning code"

The "Learning code" function allows you to pair several bells or buttons into one group or to restore the connection between them. You can use several buttons to ring one bell or one button to ring several bells. One bell can be paired with max. 15 buttons. One button can be paired with max. 8 bells.

Ringer connection 1:
Plug into a 230 V AC/50 Hz electrical outlet.

Connecting the doorbell 2:
Open the battery cover and insert 3x AA alkaline 1.5V pencil batteries. Observe the marked polarity. The receiver can be freely positioned, placed or hung on the mounting hole. Do not cover the speaker. Use the control buttons to set the melody and volume for both doorbells. The volume level changes from lowest to highest and back again, with one beep each time.
Connection and installation of the transmitter:
Press the flathead screwdriver into the joint on the short side and open the back cover. Using your finger or a flathead screwdriver, release the latch also on the short side and tip the inner cover to the side. Open the seal protecting the battery from moisture penetration. Replace the 3V CR2032 battery and observe the marked polarity. Then close the gasket and both covers carefully. Before attaching the transmitter, make sure the wireless connection is working properly where you want to use it. The transmitter is waterproof and can be placed outdoors. Prefer a place protected from water and excessive heat. The transmitter can be mounted on the pad using double-sided self-adhesive pads or screws with dowels, without or with a protective canopy.
Warning:
Prevent improper handling of this appliance and always follow the electrical appliance usage policy. Designed for use in the home or indoors. Do not expose the receiver (doorbell) to environments with high humidity (e.g. bathroom), avoid contact with liquids.

Transmission frequency:
433 MHz
Power button:
1× 3V CR2032 battery (included)
Power bell 1:
AC 230 V - to socket
Power bell 2:
3× AAA batteries LR03 (not included)
Operating temperature button:
-20 °C to +60 °C
Operating temperature bell:
-10 °C to +45 °C